Morso 551 Manuale Utente

Manufactured by Morsø Jernstøberi A/S . DK-7900 Nykøbing MorsE-Mail: [email protected] · Website: www.morsoe.comSquirrel - Gas StovesModel No. 551 - W

10 Figure 6 Figure 7 Figure 8 Figure 99. FINAL CHECKS9.1 Checking the full operating sequence.See figure 10.If the fire is turne

11• Turn the left hand control knob fully clockwise.• Push in the right control knob and, while keeping it depressed, turn anticlockwise t

12The pressure check should be carried out using a calibrated pressure gauge after removing the test point screw. The fire should be alight and the lef

138. If the above test is satisfactory, open all internal connecting doors, hatches, etc. in the room. Keep all doors and windows that open to the out

14• Recommend that the appliance should be serviced and the flue checked by a competent person (In the UK preferably a CORGI registered person) at leas

15

16Morsø Jernstøberi A/S - 18.12.2006 - 72146100

2LIST OF CONTENTSSection Heading Page1. SAFETY 32. APPLIANCE DATA 33.GENERAL INSTALLATION REQUIREMENTS 44. STOVE LOCATION

31. SAFETYInstallerBefore continuing any further with the installation of this appliance please read the following guide to manual handling.• The lift

4The stove dimensions are shown in figure 13. GENERAL INSTALLATION REQUIREMENTSThe installation must be in accordance with these instructions.For the u

5In the Republic of Ireland the installation must also conform to the relevant parts of:a) The current edition of IS 813b) All relevant national an

6Ventilation: Normal adventitious ventilation is usually sufficient to satisfy the ventilation requirements of this appliance. In GB reference should b

7allow a connection from any direction. The elbow includes a valve for isolating the gas supply.• The supply pipe must be rigid material. Flexible

88. FITTING THE CERAMIC FUEL EFFECT & BURNER COMPARTMENT WALLS1. The door is secured with a locking screw. Remove the screw with the allen key

910. Locate the remaining two ceramic coals identified with a number ‘1’ as in figure 8.11. Locate the two ceramic coals identified with a number ‘3’ as